Kitchen Worktop FAQs

In the unlikely event your question cannot be answered here don't hesitate to get in contact with us; either contact us using the form here or give us a call on 01977 559 821 between 9am and 5pm Monday to Friday or 07590 950 038 (until 9pm).

Q. Does my whole kitchen need to be in place for the site survey?

A. No just the base units need to be fixed into position.

Q. Can I plaster the walls in between Template & Fitting?

A. No, this needs to be done either before Templating or after Fitting, your worktops will not fit if you plaster in between!

Q. What is the difference between Square & Coved upstands?

A. Square upstands show a joint line whereas Coved upstands are a continuation of the worktop. Also Square upstands will follow the contours of the wall whereas Coved upstands run from point to point and quite often leave gaps of over 10 mm if your walls are undulating.

Q. Will my walls be even if they has been newly plastered.

A. No, there are no guarantees that your plasterer will have left you with even walls, please check this prior to choosing your upstands.

Q. Are you able to fit my hob and sink?

A. We will install both units, however, we are unable to plumb the units in. For gas hobs you must arrange for your own Corgi registered gas fitter.

Q. Are you able to provide samples?

A. Of course. Please contact us to arrange for samples. A small charge will be applied, however we will re-imburse this if you proceed with your worktop order.

Q. I need further advice, can you help?

A. Certainly, you can call us on 01977 559 821 between 9am and 5pm Monday to Friday or 07590 950 038 (until 9pm). You can also get in touch using our contact form and we'll get back to you as soon as we can.